Wireless Weather Station Anemometer Out Wind Speed Direction Sensor Digital Wind Chill Temperature Humidity Meter

Profeional Wirele Weather Station Anemometer With Wind Speed Direction Sensor Digital Wind Chill Temperature Humidity MeterThank you for purchasing the Digital Wirele Weather Station with Dual Mount Wind Sensor. This state-of-the art measurement instrument is engineered and designed to meet the highest quality standardsto aure you uncompromising This instrument will provide measurements of wind speed & direction, wind chill, temperature&humidity.Specification:Indoor/outdoor temperature display. Display units options:F / C(user setting). Indoor temperature range: 32F to 122F (0C to 50C); Outdoor Temperature range: Alkaline batteries: -4F to 140F (-20C to 60C) Lithium batteries: -40F to 140F (-40C to 60C); Resolution (for both indoor/outdoor temperature): 2F/1C Temperature accuracy: 2F/1C Humidity range: 20% to 90% Humidity accuracy:5% Receiver: Alkaline battery: 2 AAA 1.5V Wind Gauge Remote Sensor: Alkaline battery: 2 AA 1.5V or AA lithium battery(Not Included) Battery life: 12 months (Approx.) Station dimension: 20.5 height x 9 diameter Receiver dimensions: 4.9 height x 2.7 width x Display dimension: 2.36 height x 1.77 width Perpetual Calendar: The hour display format can be set between 12 hour format or 24 hour format. The time zone can be set from-12 to +12(user setting). Daylight saving time is adjusted automatically (The daylight saving time is adjusted on the basis of different time zone). The date display format can be set as: YYYY-MM-DD, MM-DD- YYYY,DD-MM-YYYY (user setting). Wirele 433 MHZ receiving. Available distance: 328 ft in open field. While receiving RF, pre any key to quit. Indoor/outdoor relative humidity (RH %) display. Display range: 20% to 99%. Resolution: 5%. Wind-chill temperature display. Display units options: F / C (user setting). Dew-point temperature display. Display units options: F / C (user setting). Wind speed and wind direction display. Average wind speed and gusts display. The units can be set as m/s,km/h,mph,knots or bft (user setting). Wind speed range: 0 to 50 m/s; Wind direction range:E,S,W,N,SE,NE,SW,NW. All maximum/minimum data can be recorded and displayed. In addition, the time of recorded data can be displayed as well. The weather alarm can be set separately, any value can be set. The alarm signal lasts 2 minutes.Troubleshooting:If the Receiver does not receive a transmiion from a remote unit channel for 10 minutes, the wind speed, outdoor temperature and humidity will show dashes. To correct this problem: 1. Go to the remote location of that channel to check that the unit is properly positioned, within the appropriate transmiion range. 2. If batteries are faulty on the initial installation, install fresh batteries. If you did not notice the Low Battery icon warning and the product performed correctly after initial set up, the batteries have lost their charge. Replace the batteries. 3. Check to make sure the transmiion path is clear of obstacles and interference.Use & Care:1. The home receiver is intended for indoor use only. It is not sealed against moisture and could be damaged if used outdoors. 2. Do not immerse the receiver in water. If you spill liquid on it, dry immediately with a soft, lint-free cloth. 3. The Wind Gauge Remote Sensor is weather resistant but not waterproof. Do not immerse it in water or allow snow to accumulate on it. If this accidentally occurs, dry it immediately with a soft, lint-free cloth. 4. Though the Wind Gauge Remote Sensor is weather-resistant, it should not be left outdoors in extreme weather conditions. If these conditions become likely to occur, temporarily move the transmitter to an indoor area. Otherwise, permanent damage to the sensor's internal circuits or external wind vane may occur. 5. Do not mount the Wind Gauge Remote Sensor on a metal surface. 6. Do not subject the Wind Gauge Remote Sensor to extremely severe temperatures. 7. Do not clean either unit with abrasive or corrosive materials. This may scratch plastic parts and corrode electronic circuits. 8. Do not subject either unit to exceive force, shock, dust, temperature or humidity. This may result in malfunction, shorter electronic life span, damaged battery or distorted parts. 9. Do not tamper with either unit's internal components. Doing so will invalidate the warranty on this product and may cause damage. The unit contains no user-serviceable parts. 10. Do not mix old and batteries. Do not dispose of batteries in fire. Batteries may explode or leak. Do not mix Alkaline, carbonzinc (standard) or Nickel-Cadmium (rechargeable) batteries. Remove the batteries if the units will not be used for a long period of time. 11. Always read the instruction manual before operating this product.Important:Though the Wind Gauge Remote Sensor is weather-resistant,it should never be submerged in water. If extreme weather conditions are likely to occur, temporarily move the transmitter to an indoor area for protection.