Wireless Remote Control Switch SingleChannel Learning Smart Electrical Equipment AC220V Item Type: Wireless Remote Control Switch Material: PCB Working Frequency: 315MHZ/433MHZ (default 315MHZ) Working Mode: Jog M4/self-locking T4/locking L4 Code Matching Method: Smart learning type Receiving Sensitivity: ≥105dBm Output Current: Inductive ≤3.5A, resistance ≤6A Shell Size: Approx. 81 x 38 x 22mm / 3.2 x 1.5 x 0.9in Inner Panel Size: Approx. 55 x 31 x 17mm / 2.2 x 1.2 x 0.7in The receiver has the following 3 working modes can be set, single-channel jog, single-channel self-locking, single-channel interlock (you can change the working mode according to your own needs, but remember to change the working mode when the power is off. Under circumstances!) 1. Jog: Insert the black jumper cap on the receiver into the 2+3 pins to be jog. The board has a mark M (function literal translation: press and hold the remote control button to work, release it to stop !) 3. Interlock: Leave the three pins 1, 2, and 3 of the black jumper on the receiver vacant as interlock L (Function literal translation: press the remote control A button to open the B button to close or the A button to close the B button Is on. If the remote control has multiple buttons, it will learn which button is on, and all other buttons are off!) Add or Remove the Instructions for Using the Remote Control: 1. Learning: Press the learning button on the receiving board once the green light is on and release it, and then long press any key on the remote control to learn. After the green light flashes quickly, it means that the key has been learned and the key can control the operation. 2. The 2262, 2260, 1527 chip equivalent frequency fixed code learning code wireless remote control that can learn more than 20 different address codes; 3. Clear code: long press the learning button on the receiving board for more than 5 seconds, the green light turns from bright to flashing and then goes out, indicating that the clear code is successful.