Function: The wireless remote control allows the winch to be operated within a range of 50 feet without the need for cables or switches. Easy to operate, you can start, stop, retract or extend the winch by pressing the remote control transmitter. Suitable for most self-recovery winches, such as Warn, Ramsey, Superwinch, Smittybilt, Gorilla, Bulldog, etc. Designed with visual light indicator, which can clearly and intuitively display remote operation, convenient to use. Manufactured to original manufacturing specifications, under strict quality standards, long service life. Specification: Item Type: Winch Remote Control Kit Material : ABS metal Battery type: alkaline battery (included) Battery capacity: 150mAh Battery model: 12V 23A Frequency: 434MHz Voltage: 12V Remote Size: Approx. 43x100mm/1.7x3.9 in Receiver Size: Approx. 43x70mm/1.7x2.8 inches Package List: 1 x remote control 1 x Receiver 1 x Manual Wiring: 1 . Red wire: positive () 2 . White wire: OUT 3. Yellow wire: IN 4 . Black Wire: Negative (-) 5 . Blue wire: antenna Characteristics: The remote range is up to 50 feet. The transmitter is equipped with a long service life. Battery and power saving circuit. transmitter and receiver. The visual indicator shows the remote control. An additional transmitter that can be used to operate the receiver. Installed in minutes. A replaceable transmitter battery is available at any time. Suitable for truck, ATV, SUV The wireless remote control is for the front self-recovery winch only. The remote control is not intended and is not used in industrial applications (transporter/commercial vehicle transporter, scrap metal, crane, etc. ) or in any other remote control application of winches or cranes. We recommend operating the winch as follows: 1 . Loosen the winch clutch. 2 . Pull out the winch rope about 1.5 meters. 3. Re-engage the winch clutch. 4 . Insert the plug of the remote control receiver into the female connector of the winch solenoid control box. If your wireless remote control is type -03, you should properly connect the black ground wire to the negative pole of the battery. 5 . Place the receiver somewhere. 6 . Keep the receiver antenna straight. 7 . Pull out the transmitter antenna and lower the transmitter cover to reveal the control buttons. 8 . Press the button, you can control the winch to start, stop, go in and out. (It is strongly recommended to find a professional to install)