Compatibility: Replacement strip compatible with Festool 495209 and 495207 splinter guards. Fits Festool FS/2, FS/2 KP, FSK guide rails, and Festool rail saws. Regular replacement helps maintain splinter-free cuts, especially when switching between saws or using the guide rail with multiple tools. Function: Replace the splinter guard as needed to ensure precise alignment of the guide rail with the cutting line and to prevent material tearing during parallel and lateral cuts. The new splinter guard aligns accurately with the saw blade, improves cutting precision, and reduces setup time. Clear design enhances visibility of the cutting line. High Quality: Made from high-quality soft rubber with strong adhesive backing. Features high transparency and strong adhesion for secure attachment to the guide rail without peeling off easily. Easy to Install: Pre-cut edges reflect the exact cutting line, allowing precise placement at the scribe mark. Simply remove the protective tape before use. For best results, clean the guide rail thoroughly with acetone and ensure the surface is free of grease and residue before applying the new splinter guard. Installation Tips: - Work on a clean surface to avoid dust or debris adhering to the adhesive. - Peel off the adhesive liner carefully to prevent trapping debris. - Use a plastic scraper and acetone to remove any leftover adhesive before installation. - When reapplying, position the splinter guard slightly offset if needed to allow for clean cutting. Color: As shown in photo Material: Plastic Package Contents: 1 x Splinter Guard Replacement Strip Note: - Allow 1–3 mm for manual measurement deviation and 1–3 g for weight variation. - Product color may vary slightly due to lighting conditions and monitor display differences.