Screen Vector Network Analyzer LCD 50KHz-1.5GHz USB 5V 200mA Antenna Analyzer Shortwave VHF UHF Measure Duplexer Filter

₩208,090
무료 배송

Screen Vector Network Analyzer LCD 50KHz-1.5GHz USB 5V 200mA Antenna Analyzer Shortwave VHF UHF Measure Duplexer Filter

  • 브랜드: Unbranded

Screen Vector Network Analyzer LCD 50KHz-1.5GHz USB 5V 200mA Antenna Analyzer Shortwave VHF UHF Measure Duplexer Filter

  • 브랜드: Unbranded
가격: ₩208,090
판매자::
₩208,090
무료 배송

재고 있음

다음의 결제 방식을 사용하실 수 있습니다

설명

["brand new and high quality\nFeatures:\n4-inch full-view LCD screen, with added for DC dimming, can be seen more clearly when used outdoors. Indoor use is more comfortable.\nThe bridge has been optimized to make full use of the harmonics of Si5351, and the 5th harmonic can now be used to measure up to 1.5GHz.\nWhen the fundamental wave is used, the CH0 output level is increased to 0dBm, and the reflection measurement is more accurate.\nThe previous abnormality of Nanovna-H near 6MHz was resolved.\nReproduce the design of the power management circuit, further reduces power supply noise, reduces USB power supply interference, reduces charging current, and protects the battery.\nOptimized PCB layout, accommodating 1950mAh battery, used for more than 8 hours.\nUART interface is reserved to facilitate DIY expansion.\nLightweight ABS housing provides good for protection for the device.\n\nSpecification:\nMeasurement Frequency: 50KHz~1.5GHz\nRF Output: 0dbm (±2dB, fundamental wave)\nFrequency Accuracy: <2ppm\nFrequency Stability: <0.5ppm\nMeasurement Range: 70dB (50kHz-300 MHz), 60dB (300M-900MHz), 40dB (0.9G-1.5GHz) enable expansion firmware)\n(Note: Please pay attention to the error caused by nonlinear transformation of the fundamental wave when using harmonic measurement.)\nPort SWR: <1.1\nDisplay: 4in TFT (320 x 480)\nUSB Interface: USB type-C Communication Mode: CDC (serial)\nPower Supply: USB 5V 200mA, Built-in 1950mAh battery, Maximum charging current 1A\nNumber of Calibration Points: 101 (fixed)\nNumber of Scanning Points: 101 (fixed)\nDisplay Tracking: 4, Marking: 4, Save Setting: 5\nMeasurement of S-parameters, voltage standing wave ratio, phase, delay, Smith chart, for time domain analysis, et\nMaterials: Metal+ABS\nPackage Size: app.24x14x3cm/9.45x5.51x1.18in\nColor: As pictures shown\nQuantity: 1set\n\nNote:\nPlease allow 0-1cm error due to manual measurement. pls make sure you do not mind before you bid.\nDue to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!\n\nPackage includes:\n1 x NanoVNA Main Unit(Including 4 inch for touch screen, 1950mAh battery)\n2 x 15cm SMA Male to Male RG316 RF Cables\n1 x SMA Female to Female Connector\n1 x SMA Simple Calibration Kit SHORT\n1 x SMA Simple Calibration Kit OPEN\n1 x SMA Simple Calibration Kit LOAD\n1 x USB Type-C Data Cable\n1 x Type-C to Type-C Cable(other accessories demo in the picture is not included.)"]
  • Fruugo ID: 369484712-800587472
  • EAN: 7927015236138

배송 및 반품

24시간 이내에 발송됨

  • STANDARD: 무료 - 배달 사이 목 02 10월 2025–화 07 10월 2025 - 무료

중국에서 발송.

당사는 귀하께서 주문하신 제품이 주문 명세에 따라 빠짐없이 배송되도록 온 힘을 기울이고 있습니다. 다만, 주문하신 것과 다른 상품이 배송되거나 빠진 상품이 있는 경우, 또는 주문 내용에 만족할 수 없는 다른 이유가 있는 경우에는 주문 전체나 주문에 포함된 일부 제품을 반품하시고 해당 상품에 대해 전액 환불받으실 수 있습니다. 전체 반품 정책 보기

製品コンプライアンスの詳細

以下に概説されているこの製品に固有のコンプライアンス情報を参照してください。

以下の情報は、この製品を販売する独立したサードパーティ小売業者によって提供されています。

제조사:
다음 정보는 Fruugo에서 판매되는 관련 상품의 제조사 연락처입니다.

  • Shenzhen Yiyuxun Hardware Tools Co., Ltd.
  • Shenzhen Yiyuxun Hardware Tools Co., Ltd.
  • Room 205, Building D10, No. 5, Cengyao Industrial Zone, Yulv Community
  • Yutang Street, Guangming District
  • Shenzhen
  • China
  • 518000
  • cyjeniaunr@163.com

EU 내 책임자:
다음 정보는 EU 내 책임자 연락처입니다. 책임자는 유럽 연합에서 판매되는 관련 상품에 대한 준수 의무에 책임을 지는 EU에 기반을 둔 지정 경제 주체를 말합니다.

  • Yating He
  • E-CrossStu GmbH
  • 69 Mainzer Landstrasse
  • Frankfurt am Main
  • Germany
  • 60329
  • E-crossstu@web.de
  • +4969332967674