RadioLink R8EF 2.4GHz 8CH Long Distance PWM PPM SBUS RC Receiver for T8FB T8S RC Transmitter RC Airplane Car Boat Specification: Brand: Radiolink Product Name: R8EF Size: 41.5*21.5*11.5mm Weight: 14g Antenna Length: 210mm Number of channels: 8 channels Supported models: car/boat/glider/fixed wing Working voltage: 3V-15V Working current: 38-45mA (input voltage 5V) Frequency: 2.4GHz ISM band Spread spectrum method: FHSS 67 channel pseudo-random frequency hopping Control distance: 2000 meters in the air, the actual flight distance varies with the environment Compatible remote controller: RC8X/T8FB (standard)/T8S/RC6GS V2/RC4GS V2/RC6GS/RC4GS Applicable Transmitter Model Radiolink R8EF 2.4G 8CH receiver, suitable for RadioLink 8CH remote controllers T8FB (standard), T8S, RC4GS V3, RC6GS V3, RC4GS V2 and RC6GS V3. Signal Output Type Supports simultaneous output of three signals: SBUS, PPM and PWM. Signal Working Mode 1. PWM signal working mode The receiver indicator light is red, and 8 channels of PWM signals are output. 2. S-BUS/PPM signal working mode The receiver indicator light is blue (purple), channel 1 outputs S-BUS signal, channel 2 outputs PPM signal, and channels 3-8 output corresponding PWM signals, a total of 8 channels of signals are output. Signal Switching Short press the (ID SET) switch on the side of the receiver twice (within one second) to complete the switching of R8EF's PWM signal and SBUS or PPM signal. Binding Each transmitter has an independent ID code. Before using the device, the receiver must be bound to the transmitter. After the binding is completed, the ID code is stored in the receiver and does not need to be bound again. When you purchase a new R8EF receiver, you must re-bind it, otherwise the receiver will not work properly. 1. Put the transmitter and receiver together, with a distance of less than one meter between them. 2. Turn on the transmitter power switch. The R8EF receiver will search for the nearest remote controller for pairing. 3. Press the (ID SET) switch on the side of the receiver for more than 1 second, and the LED light will flash, indicating that pairing has started. 4. When the indicator light stops flashing, pairing is complete. 5. Please make sure that your servo can be operated according to the transmitter. Package Included: 1x Radiolink R8EF Receiver