1. Keep the tires working within the specified pressure and temperature range at all times to reduce tire damage and extend service life. 2. Avoid excessive or uneven tire pressure to reduce wear on the suspension system. 3. When the tires have high pressure/low pressure/high temperature, the alarm will remind the car owner to pay attention to driving safety, which will also help save fuel and money. 4. Track tire status to prevent tire leaks and punctures, saving fuel and being environmentally friendly. 5Replace the OEM number for reference: 40700-3VU0A. Condition: Item Type: Tire Pressure Sensor Color: As shown OEM: 40700-3VU0A Frequency: 433 MHz Accessories: Fits Nissan Rogue 2014-2016 External tire pressure sensor installation steps: 1. Unscrew the valve cover; 2. Screw in the hexagonal nut; 3. Rotate to the corresponding tire according to the position of the sensor; 4. Use a nut wrench to rotate the top in the opposite direction to tighten the sensor; 5. Use soapy water to check for air leaks. Note: The external tire pressure sensor replaces the original tire pressure sensor position and the built-in tire pressure sensor installation steps: 1. Remove the original tire valve; 2. Install the tire pressure sensor (the installation location is marked on the sensor). This step requires tire picking; 3. Inflate the tire and cover the mouthpiece; 4. Dynamic balancing machine test; 5. Adjust the balance weight and install the balance weight (must be thoroughly cleaned and dried). Tire pressure monitoring learning operations and precautions: a. Park the vehicle on level ground and prepare an air pump or air pump; b. Turn off the brake, pull up the handbrake, and turn the key to the 0N position (the entire vehicle is powered on, no ignition); c. Press the (MENU) key on the turn signal operating lever to switch to the vehicle information bar and find the tire pressure monitoring interface (as shown in the front right picture); d. Press and hold the SET button for about 3 seconds to enter the tire pressure relearning interface. After the selection is completed, the horn will beep twice continuously, indicating that tire pressure monitoring learning has started (rear left); e. At this time, the left turn signal is on (right rear), prompting the left front wheel to deflate (can be deflated) until the horn sounds, the left turn signal is off, and the right turn signal is on. After learning is completed and stop deflating, the tire pressure learning sequence is: left front wheel - right front wheel - right rear wheel - left rear wheel: f. After the rear wheel is deflated, the horn will beep twice to indicate the end of tire pressure monitoring learning. }4 x Tire Pressure Sensor Please check the part number of your item carefully, the matching information is for reference only. If you are not sure about the item, please contact us before purchasing to avoid unnecessary, thank you