- User-friendly Dial: A 3-point position dial allows seamless switching between rinse, solder, and shutdown modes to match the required nitrogen flow rate for your task. - Quick Connection: The 1/4 inch connector easily interfaces with standard nitrogen regulators, enabling fast setup and minimal downtime for rinsing and soldering tasks. - Effective Dirt Removal: Smoothly introduces nitrogen into pipes during rinsing and soldering, effectively removing dirt and helping keep your system clean. - Precise Pressure Control: Inlet pressure of 50 psi and a maximum of 200 psi provide accurate control of nitrogen flow for consistent flushing while reducing gas waste. Use scenarios: - Purge and rinse new or repaired piping before soldering to ensure a clean joint. - Purge lines during soldering or maintenance in plumbing, HVAC, or industrial piping to minimize debris and contamination. - Quick line conditioning and cleanup in workshop settings where fast, controlled nitrogen purge is required.