Fitment: For Kawasaki ZX-6R (2003-2008) For Kawasaki ZX-6RR (2003-2006) For Kawasaki Z750 (2004-2006) For Kawasaki Z1000 (2003-2006) For Kawasaki ER-6N (2006-2011) For Kawasaki ER-4N (2010-2014) For Kawasaki ER-4F (2010-2012) For Kawasaki ER-6F (2006-2011) For Kawasaki Ninja 250R [FI only, not in USA] (2008-2012) For Kawasaki Ninja 400R (2010-2012) For Kawasaki Ninja 650R (2006-2011) For Kawasaki KLE650 (2006-2009) For Kawasaki Versys650 (2006-2009) For Kawasaki ZRX1200 DAEG (2009-2010) For Kawasaki Vulcan 900 (2006-2010) For Kawasaki VN900 (2006-2010) For Kawasaki Vulcan 1700 (2009-2010) For Kawasaki VN1700 (2009-2010) For Kawasaki KFX450R [ATV] (2008-2010) For Kawasaki Vulcan 2000 (2004-2010) For Kawasaki VN2000 (2004-2010) For Kawasaki KVF 750 [ATV] (2008-2010) Condition: Item Name: Speed Gear Display Indicator Size: 4cm*4cm*4cm / 1.57inch*1.57inch*1.57inch Feature: Shows current gear number Indicates current gear from 1 to a maximum of 6, as well as a neutral indicator. Detects the current gear faster than other gear indicators that use speedometer/tachometer signal. Display can be mounted anywhere Installation: Find the 4-pole male diagnostic connector (DLC), usually near the ECU box. It may have a removable cap and may be partially covered by black tape. Note: Some motorcycle models may have two of these connectors on the bike. The color is generally black. In this case, try both connectors, but only one will supply data to this gear indicator. It will not harm your bike if you connect the gear indicator to the wrong plug first. Foreword: Congratulations on your purchase of this gear position indicator. Unlike other gear indicators available for your bike, this product connects to the diagnostic connector, making installation very simple. The unit reads data directly from the ECU, offering faster and more reliable readings than competing products. The display is auto-learning, with no buttons and no programming wire. Know limitations: Your bike is not equipped with a Gear Position Sensor. Therefore, determining the gear in use is only possible when the engine is running and the clutch is released. Troubleshooting: You may find two black connectors on the bike with a removable cap or dummy plug. Try the second one if the unit does not work from the first one. Disconnect the gear indicator connector and check whether the pins are broken, bent, or pushed out of position. Reconnect the plug and make sure that all connections are good and the connector is fully seated. If you cannot execute the setup procedure, your battery might be old or weak. Charge the battery or connect another battery using a jumper cable. If some gears are not indicated properly when the engine is running and the clutch is released, reset the unit and set up again. If the problem persists, your clutch might be slipping. Package List: 1 x Motorcycle Speed Gear Display/Bracket (As shown in the option picture)