["Description:\nbrand new and high quality\nFeature:\nMain function: When refitting the LED of some motorcycles, because the power of the halogen lamp of the original car is different from the power of the LED lamp after the modification, the motorcycle will check out the power mismatch, so there is a failure, no flash or strobe, etc. It is necessary to install an LED decoder to remove the fault light alarm and other problems caused by the modification of the LED light.\nMain purpose: some vehicles will change the LED lights after installation, the steering lights will flash quickly, or do not flash. The newly installed LED lights will report errors and other phenomena. The addition of this product can solve the flashing of the steering lights and remove the ED light fault alarm. Motorcycles are suitable.\nInstallation instructions: The left and right lines of the turn signals are different. If you change the LED lights on the left and right, install one on each side. If you change the lights on the left and right, you can only install two, but the left and right turn lights (use (A resistor) and the front right and rear right turn signals (use a resistor) must be connected to the resistor with a wire. For ease of installation, it is recommended to install a resistor for each turn signal.\nLED Indicator Resistor only, other accessories demo in the picture are not included.\n\nSpecifications:\nItem Type: LED Indicator Resistor\nMaterial: electronic components\nSize: decoder 2.8x1.5cm/1.1x0.5in, cable length: 15cm/5.9in\nColor: Black+Red\nPower: 10W\nResistance: 10Ω\nQuantity: 1 Set(4pcs)\n\nNote:\nTransition: 1cm=10mm=0.39inch\nPlease allow 0-1cm error due to manual measurement. pls make sure you do not mind before you bid.\nDue to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!\n\nPackage Includes:\n4 x LED Indicator Resistor"]