Features: 5-inch IPS 800x480 resolution display screen. Capacitive touch screen panel. Support Raspbian multi-touch, support Ubuntu/Kali/Win10 loT single touch, and support Retropie. MIPI DSI interfaces for Raspberry Pi are directly output, plug and use, no need to install driver. There is no need for separate power supply, touch+display+power supply are all solved by one flexible cable. Specifications: Size: Approx. 12x7.6cm/4.72x2.99 inch Screen Size: 5.0 inch IPS Screen Resolution: 800x480 Display Port: MIPI DSI Touch Type: Capacitive Touch Points: 5-points Touch Port: 12C Touch Panel: Tempered Glass Panel Power Saving: Low Power Consumption Note: 1.The screen is applicable to the 4B/3B/2B MIPI DSI interface for Raspberry Pi, and cannot be used for the computer host or without MIPI DSI interface for Raspberry Pi motherboards (such as Zero) can not be adapted to other chip motherboards; 2. Since the system for Raspberry Pi has created a new system branch, the following comments should be marked in the config.txt file for systems after May 21 Statement (the config file is located in the root directory of the TFcard, that is, in/boot): # dtoverlay=vc4-kms-v3d (that is Add # at the beginning. Note that there are two sentences that are the same. It is better to comment them out); 3. Please connect or disconnect the flat cable after powering off for Raspberry Pi, otherwise the display screen and board for Raspberry Pi may be damaged. Package includes: 1x 5.0" Capacitive TouchScreen 2x Flat Cables