Feature: 1. DUAL POWER SUPPLY: Motor controller board supports dual power supplies (both power supplies cannot be powered at the same time). Power supply 1, DC 6.5‑25V. Power supply 2, DC 5V. 2. OPERATING CURRENT: Forward reverse motor control board standby current 41mA, operating current 83mA (normal mode). Standby current 7mA, operating current 45mA (energy saving mode). 3. THREE INPUT CONTROL PORTS: Motor control board has three input control ports, forward control, reverse control and stop control. Two input trigger modes, low pulse trigger mode and low level trigger mode. 4. DELAY TIME AND CYCLE: Motor forward reverse controller board delay time 0.1‑999.9 seconds, 1‑9999 seconds, 1‑9999 minutes. Cycle times are no cycle, 2‑99 cycles, forever cycle. 5. THREE INDICATOR LIGHTS: Delay time motor controller board has three indicators, forward indicator, reverse indicator, and stop indicator. 6 function modes. Relay load current, less than 5A is recommended. Specification: Item Type: Motor Control Board Material: PCB Ports: DC 5.5mm/0.2in Female : Power Supply 1,DC 5V Supply. VIN: Power Supply 2 Positive, DC 6.5-25V Supply GND: Power Supply 2 Negative FWD: Forward Input Control (Part Of The Function Mode Is Invalid) REV: Reverse Input Control (Part Of The Function Mode Is Invalid) STOP: Stop Input Control (Part Of The Function Mode Is Invalid) M+: Motor Positive M-: Motor Negative P+: Motor Power Positive P-: Motor Power Negative. Package List: 1 x Motor Control Board