CT-02B Multi-Purpose Audio Cable XLR Test Instrument Engineering Wiring Multifunctional Cable Teste J2

Color: Yellow Material: Metal Cable Testing:1. You need to put in a 9V battery, then turn the rotary switch fully clockwise to test thebattery strength. 2. Then plug one end of the cable into the appropriate jack on the left side panel of the cable tester, Plug the other end of the cable into the appropriate jack on the right side panel. Set the rotary switch to "1" to test the connection of contact 1 on the plug inserted into the left side panel. 3. lf there is a connection, the Green LED light below "1" and a Yellow LED light above each contact on the right side plug connected to "1" on the left side plug. Use the charts below to verify proper cable connections. 4. If no LED lights than there is no connection and the left side contact "1"is "floating" due to designor an "open" in the cable. 5. Set the rotary switch to "2" to test contact 2, and so on, until all contact shave been checked. 6. If the Ground LED lights than there is a connection between the corresponding contacts and the chassis. 7. To test the cable with a banana plug, just plug each end of the cable into the banana jacks. Interface:USB/6.3mmjacks/3-pin XLR/3-pin DIN/5-pin DIN/4-pin speakon Package Contents: 1 x Cable Tester(Without 1x9V battery,You need to prepare yourself) Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.