NoteThe Size: PullerKit does not contain glue. If you need to, simply buy Glue Gun and Glue Sticks additionallyPacking lncluded:Puller Kit (No Glue):1 * Puller,18 * Tabs, 1 * Towel,2 * Shovel(Glue gun glue stick not included)Only Glue Gun EU Plug:20W EU PlugGlue Gun(Glue stick and puller are not included)Only Glue Gun US Plug:20W US PlugGlue Gun(Glue stick and puller are not included)Only 10Pc Glue Stick:10 Pcs 7 * 270 mmGlue Stick(Glue gun and puller are not included)Features:100% Brand new and high quality.It is made of aluminium alloy compatible strong strength and long durability.Used as a adapter compatible slide hammer or pulling tap compatible easy catching and pulling.A necessary component compatible dent repair, direct compatiblement compatible the broken one.Easy installation, the thread size is M10 compatible better application.Specification:Material: Aluminum AlloyColor:As the picture showType: M10Size: As the picture showHow to use this paintless dent repair kits :1.Clean the dent with a clean wet cloth2.Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat compatible 5 minutes3.Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger thedrawing gasket is, the larger the drawing compatiblece is)4. Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue)5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool compatible about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter)6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen8. Clean the repaired place with a clean wet cloth