설명
Working Voltage: AC/DC 12V-36V
( AC&DC both are ok. Wide working voltage from 12V to 36V(12V 14V 16V 18V 24V 28V 36V)
Working Current: 48ma
Quiescent current:16ma
Max Load: 10A Relay ( have better load less than 5A (60W)
color: White
Material: ABS
Function: Receiver Manual Button Control & Wire External Button (without transmitter)
( Wire the Normally Limited to the External Button Pin ( U--S--D--GND) make your motor Forwards Reverse
2. Original State OFF, (Suddenly, the electricity cut off, then comes again, the State still is OFF, you need manual turn it ON)
3. Out State: Momentary Toggle Latched Adjusted by the Jumper on the Receiver,
( we default as Latched, if you need use Momentary to change the Jumper on the Receiver ,Notice, 't use Toggle)
4. Momentary----------Jumper on "1&2"
5. Latched-----------Jumper on "3&4"
6. Momentary -------------
Press button"Up", the Motor Forward, Release is Stop.
Press Button "Down", the Motor Reverse, Release is Stop.
Latched------------------
Press button "Up", the Motor Forward, Press Button "Stop" is stop.
Press Button "Up", the Motor Reverse, Press Button"Stop" is stop
7. If you 't need wire the Limited Switch, you need connect the UP Down and with a Line, we have connect it we out ,if you need use it take that is ok.
8. When the receiver output state is "Latched", we have set it 0.5s time delay for forwards and reverse, it is the Protection function.
Package Contents:
1 x Wireless Remote Controller(2 CR2016 button batteries not included)
1 x Receiving Controller
Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
-
Fruugo ID:
345150908-755269593
-
EAN:
9355261031616