DescriptionPower supply mode DCContinuous output current 2AInput voltage 48VSuitable motor DCMaimum applicable motor power 60W. Maimum output current 3AInterface1. VCC Connect to the positive pole of the DC 5V power supply2. GND Connect the negative terminal of the DC 5V power supply, which must be grounded together with the signal terminal3. IN1IN8 Connect to the IO port of a microcontroller or PLC4. HL jumper H is high level, L is low level, and the middle is the common terminal5. VIN Load side power supply DC positive level, GND Load side power supply DC negative pole6. Connect the load terminals OUT1OUT8 to the positive pole of the load deviceConnect the load terminal GND to the negative terminal of the load device1. Indicator light The 5V version comes with an indicator light that lights up when there is a signal2. Application scenario The output end can control highpower DC devices such as motors, light bulbs, LED light strips, DC motors, micro water pump solenoid valves, etc. PWM can be input to control motor speed, brightness, etc. 3. The voltage range of the control terminal is DC 5VDC48V. Since the control board has not undergone highpower heat dissipation treatment, it is recommended that the single power does not eceed 60W 4. The control end and the signal end are isolated by optocouplers, please useSpecifications A5V versionColor As shownMaterial plasticPackage contents1 8channel MOS module