Features: 5-inch IPS 800x480 resolution screen. Capacitive touch panel. Supports Raspbian multi-touch, Ubuntu/Kali/Win10 IoT single touch, and Retropie. MIPI DSI interface for Raspberry Pi direct output, plug and play, no driver installation needed. No separate power supply needed; touch, display, and power are all handled by a flexible cable. Specifications: Size: Approx. 12x7.6 cm / 4.72x2.99 inches Screen Size: 5.0 inch IPS screen Resolution: 800x480 Display Port: MIPI DSI Touch Type: Capacitive Touch Points: 5-point Touch Port: I2C Touch Panel: Tempered glass panel Power Consumption: Low power Note: 1. The screen is applicable to 4B/3B/2B MIPI DSI interfaces for Raspberry Pi and cannot be used for computer hosts or motherboards without MIPI DSI interfaces (such as Zero) and cannot be adapted to other chip motherboards. 2. Since the Raspberry Pi system has created a new system branch, the following comments should be marked in the config.txt file for systems after May 21st (the configuration file is located in the root directory of the TF card, i.e., in /boot): # dtoverlay=vc4-kms-v3d (i.e., add # at the beginning. Note that there are two identical sentences. It is better to comment them out). 3. Connect or disconnect the flat cable after turning off the Raspberry Pi, otherwise, the screen and the Raspberry Pi board may be damaged. Package Includes: 1x 5.0" Capacitive Touch Screen 2x Flat Cables