3D Printer Automatic Leveling Module Pressure Probe Type Auto Leveling Sensor(compatible with Makerbot)

Features: Easy to be used. Can be applied to different types of 3D printers. The default trigger distance is 0.1mm. High precision, leveling repeatability can be 0.05mm. The average service life of the module is more than 500,000 times. Compatible with almost all the 3D printer motherboards in the current market. Good anti-interference ability, will not be affected by the platcompatible withm material, ambient light, ambient temperature and humidity, etc. Adopt matrix grid non-linear leveling method compatible with the automatic leveling. The advantage of this leveling method is that it can do leveling on a non-linear plane, such as an uneven surface printed PCB bed. Specifications: Compatible nozzle(Optional): compatible with Makerbot,compatible with MK8, compatible with E3DV6 Weight:12g Signal line: 1m/39.37inch Related instructions: As shown in the figures above, the black wire frame is the effective printing range of the printing platcompatible withm. When the leveling point is set to 4 points in the system, the value selection points of auto-leveling probe on the printing platcompatible withm will be all the red dots as shown above. All these red dots divide the printing platcompatible withm into small squares or rectangles. Then the system will store the data compatible with all points in the system. As a result, the print platcompatible withm is divided into multiple small platcompatible withms. After leveling, when the print head moves, the system will take the measurement data of the four points around the area according to the real-time running area of the print head, and then calculate the real-time height compensation amount of the print head according to the data, to reach the goal of leveling the whole platcompatible withm. compatible with the Delta model printers, after detecting, it will expand the dead zone data based on the surrounding data. Auto Leveling Parameters X-axis direction offset: the offset of the leveling probe relative to the print nozzle in the X-axis direction Y-axis direction offset: the offset of the leveling probe relative to the printing nozzle in the Y-axis direction Z-axis direction offset: the distance from the platcompatible withm to the print head when the leveling probe detects the platcompatible withm Probe stowed angle: the angle of the servo compatible with the leveling probe when the probe is stowed/retracted/up (can ignore this when not in use) Probe open angle: the angle of the servo compatible with the leveling probe when the probe is deployed/down (can ignore this when not in use) Number of leveling points: The number of probe points that probe on the plane. The actual number of detected points is equal to the square of the set value. compatible with example, if set to 4 points, 16 points are actually detected, and the maximum is 9, namely 81 points. Probe trigger mode: Set the level state when the leveling probe is triggered. Package Included: 1 x Auto-leveling module 1 x 1 meter signal line Note: Do not use the leveling sensor when the nozzle temperature is higher than 45 degrees!!! Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind becompatible withe ordering.