Type: front and rear stop sucker type Power: Voltage: 12V Model: 51034 LED Number: 3X6 Total 18 pcs Color: red and blue Product accessories: a lampshade, a bracket, a pack of screws, three sucker. Size: Shade size: 11 * 9 * 5CM Line length: Scales: 60CM, Scales: 180CM. Weight: 0.4KG Suitable models: 12V vehicles GM Explosion flash :: 1 three flash ways: the first and third flash at the same time, the middle layer and then flash, three at the same time flash, the first and third flash at the same time five, middle and then flash Five times. switch. Installation site: front or rear glass Size: 1, outer dimensions of 12 cm X13 cm X6.5 cm 2, strobe light size 12 cm X8.6 cm X5.2 cm 3, the natural length of the cable 80 cm Tensile length 210 cm Weight: 380 grams Uses Features: 1, encountered rain and fog weather early in the evening when the line of sight is not good to open its eye-catching red and blue burst warning traffic and pedestrians to avoid scraping; 2, vehicle traffic problems can be moved to the glass after the file open to reduce the accident rate of 15% or more; 3, the case of emergency speed faster to open the flashing lights can play a striking noise warning function in advance to tell pedestrians and traffic emergency shelter, traffic on the road and their own and car have a protective effect; 4, the trapped mountain island opened flashlight distress signal sent for time to fight for life. 5,12V vehicle general LED life of up to 50,000 hours of high brightness and low energy consumption sustainable use. Matters needing attention: 1, Before using the car battery must be confirmed that the rated output of 12V; As the cigarette lighter interface may have long-term oxide layer can lead to poor contact You can plug the cable into the left and right to rotate a few can be solved. 2, when installed in the front glass, please avoid the car vents and defrost tuyere. Installation method: 1, the fixed bracket and flashing lights properly connected and fixed; 2, and then the suction cup adsorbed on the front glass or rear glass (according to their needs) How to use: Plug the power cord directly into the cigarette lighter and turn on the flashing light. Press the red button on the left (press once to turn on Press Press twice twice to change the mode to press and press to turn off four times). Product accessories: a lampshade, a bracket, a pack of screws, three sucker.