The biggest problem in setting up a home theater is figuring out where to run the wires. When tearing up your wall is not an option, you are often left with unsightly, messy wiring around the edge of the room. Flat wire allows for neat, low-profile wire runs on your floor, walls, or ceiling, giving your installation a clean, professional look without drilling any holes. Termination Instructions: 1. Peel back and trim the adhesive backing to expose about 1 inch of the adhesive on the bottom side of the flat wire. 2. Cut around the exposed conductors and remove the backing. 3. Separate the white backing from the topside of the conductors to expose a clean copper surface. Place the removed white backing on the bottom side—the adhesive side—of the conductor. 4. Clean any remaining adhesive from the top side of the conductor using rubbing alcohol or another solvent. 5. Trim the tips of the conductors to ensure a clean, even connection point. 6. Insert the conductors into the clips on the terminal block, then secure by snapping the terminal block closed.