Oil Catch Can Tank with Bracket Application: Fit for Dodge Ram 1500 2500 3500 5.7L 6.4L HEMI (8 speed transmission) 2009-2019 Fit for Dodge Charger, Challenger, Fit for Chrysler 300, Fit for Charger 6.4L SRT8-Challenger- 300 2009 -2019 Include: Oil Catch Can Z Bracket 1/2 inch Nickel Fittings 1/2 inch HP Hose As Picture Shown Designed to eliminate oil from entering the intake by blowing out the engine which carries oil and debris into the direct airstream from the valve train. These cans are equipped with a restriction system and separator that forces all contaminants to be captured and placed in the filter while allowing air to flow, thus maintaining the full functionality of the vent system. Note: Professional installation recommended. Installation instructions Step 1 - Remove the factory or aftermarket air intake pipe . (Removing 2 Hose Clamps and 1 Sensor Plug) Step 2 - Remove the factory engine cover by lifting the front and pulling towards you. (Cut out the hose n rear alignment pins on the intake cover) Step 3 - Remove the PCV hose from the throttle body and top of the intake manifold (remove the 2 rubber ends on each side for a much cleaner installation than 2 adapter barbed fittings) Step 4 - Install Dodge Ram catch the can in the hole in the front of the cylinder head. (The mounting hole is located on the lower left corner of the passenger cylinder head freeze plug) Step 5 - Now you can install 1/2" hoses on each side of the UPR Dodge Ram catch can. (The catch can has a 1/2" straight barb connection for a straight shot into the intake manifold) Step 6 - Reinstall the air intake hose and factory engine cover to complete. (Now double check all your work)<br> Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement. Sold by-DIMEANI official store