1. Aluminum alloy material: high precision aluminum alloy cylinder, electroplating treatment, high strength, no deformation, not easy to corrode. 2. High-quality sealing ring: The cylinder is equipped with a high-quality sealing ring, which is wear-resistant, leak-proof and tightly connected. 3. Stable performance: This is a cylinder with stable performance and the same appearance and high jamming efficiency. 4. Application: Cylinders are mainly used in pneumatic and hydraulic systems, such as presses, maintenance of pneumatic and hydraulic systems, etc. 5. Easy installation: This cylinder is easy to install, stable in operation, good sealing performance and wide application. Specification: Item type: pneumatic cylinder Material: Aluminum alloy Model: MAL16-25 Action form: reciprocating type Working medium: Air Pressure range: 0.15 ~ 1.0 MPa Operating temperature: -5 ~70 End thread: Inlet thread: M5 Piston rod thread: M6 Package list: 1 cylinder Note: 1. When the load changes during work, a cylinder with sufficient output power should be selected ; 2. Under high temperature or corrosive conditions, corresponding high temperature or corrosion resistant cylinders should be selected 3. The cylinder should be protected when there is high humidity, a lot of dust, water droplets , oil stains and welding slag; 4. Before the cylinder is connected to the pipeline, the dirt in the pipeline should be cleaned to prevent debris from entering the cylinder 5. The cutoff of the cylinder should be filtered by filter element above 40M before it can be used. 6. In a low temperature environment, frost resistance measures should be taken to prevent the water seal in the system from thawing; 7. Avoid side load, otherwise the piston rod will be easily deformed and damage the thread. when the single action type cannot return; 8. It is inconvenient to remove the cylinder for a long time. Pay attention to rust prevention. Dust caps should be added to the intake and exhaust ports. 9. The front and rear covers are not removable