Features: The Engine Interface Module is a sealed, engine-mounted module that provides switching relays for the starter motor solenoid, glow plug, and fuel solenoid. Each of these circuits is protected with individual fuses mounted in the module. Individual LEDs illuminate when each circuit is energized. There are two versions of the Engine Interface Module available: EIM Basic: The EIM is utilized in conjunction with control panels equipped with overspeed shutdown. EIM Plus: The EIM Plus is used in conjunction with control panels not equipped with overspeed shutdown. Overspeed Signal (EIM Plus only): The EIM Plus monitors the speed signal from the magnetic pickup. If the engine speed rises above a certain preset value, the module sends a zero-volt signal to the generator set control panel to activate the overspeed fault circuitry. The overspeed set point is factory set at 55 Hz for 50 Hz sets and 66 Hz for 60 Hz sets. This can be adjusted using the adjustment screw accessed through the hole beside the overspeed setup LED. While the engine is running at the rated speed (1500 rpm for 50 Hz or 1800 rpm for 60 Hz), the adjustment screw should be adjusted until the overspeed setup LED just goes out. This sets the overspeed value at 10% above the speed at which the generator set is operating. Specification: Condition: Item: 630-645 Voltage: 12V DC Model: EIM PLUS Type: 859767 Package List: 1 x Engine Interface Module Note: Due to differences in lighting and screen settings, the item's color may vary slightly from the images. Slight dimensional differences may occur due to manual measurement.